Siemens SIMODRIVE 6SN11 Series Planning Manual page 111

09.00
Technical Data and Characteristics
3.1 Speed–torque diagrams
Note
For converter operation on 480 V supply networks, DC link voltages of > 600 V
are obtained. The following restrictions apply:
S
S
S
3.1.1 Standard motors
 Siemens AG 2000 All rights reserved
SIMODRIVE Planning Guide Motors (PJM) – 11.00 Edition
Motors, shaft heights 36, 48, 63 and 71 may only be utilized to ∆T = 60 K.
Shaft heights 100 and 132 may still be utilized according to ∆T = 100 K.
The shift of the voltage limiting characteristics is described in Chapter
AL S/1.1.
The specified thermal limiting characteristics are referred to ∆T = 100 K.
Note
The rotor moment of inertia for 1FT5 motors is specified without tachometer.
6SN1197–0AA20
1FT5 AC Servomotors
3.1 Speed–torque diagrams
3
1FT5/3-27
1FT5