Table of Contents
Advertisement
1.2
Safety notes
General
WARNING
Operation conditions
Only qualified personnel should be allowed to work on this drive system, and only after becoming acquainted with all the
safety notices regarding installing, connecting, commissioning, operation and maintenance as set out in this manual.
Failure to observe these notices contained in this manual can result in death, severe personal injury or considerable
damage to property. Without prior authorization, you are not allowed to perform any modification on the drive.
Identification
WARNING
Deliverables received must be complete and intact.
Exercise caution to ensure that you do not put a damaged device into service. Make sure that the drive, the motor and the
cables received correspond with the specific drive package you ordered from Siemens.
Transport & Storage
CAUTION
Drive transport and storage
Transport and storage must meet specified environmental conditions.
Do not handle the motor by gripping the connecting cable (power cable, brake cable or encoder cable) or the motor shaft.
Mechanical installation
WARNING
Installation environment
Use caution to ensure that you do not install the drive and the motor in an area which is subject to inflammables or
combustibles, water or corrosion hazards. Failure to observe may result in fire or electric shock.
Do install the drive in a distribution cabinet with an adequate protection level.
CAUTION
Mounting locations and clearance
Do not install the drive and the motor in a location where it is likely to be exposed to constant vibrations or physical shocks.
Risk of fire. Make sure that no any foreign body (such as chips of wood or metal, dust, paper scraps, etc.) falls into the
drive or lies on its heatsink.
Keep sufficient clearance between drives, one drive and another device/inner wall of the cabinet.
NOTICE
Tightening the screw on the terminal door
Siemens recommends that you tighten the screw on the terminal door of the drive, after you have completed the installation
work.
Controlled Power Module (CPM60.1)
A5E03975175-002, 04/2014
5
Advertisement
Table of Contents
