Keysight Technologies N9010B EXA Installation Note page 9

— If the analyzer's frequency range option is either N9010B-503 or N9020B-503, you do not
need to perform the Install Preselector Bypass Hardware procedure. Also, you should not
redeem the entitlement for N9010B-BUP or N9020B-BUP (as appropriate). The Install
Preselector Bypass Hardware procedure and the entitlement for N9010B-BUP and
N9020B-BUP are only for analyzers with frequency range options 507, 508, 513, or 526.
4. On the analyzer, press System, Show Hardware. Note the Part #, Matl Rev, Rev, OF Rev, and
Hw Id of the Front End Controller in the table below.
Assembly Name
Front End Controller
Digital IF
5. Refer to step 3 and 4:
— If the analyzer has N9010B-CR3, N9010B-CRP, N9020B-CR3, and/or N9020B-CRP installed
verify that it also has a Front End Controller with Hw Id of 41 or 75. If the Front End
Controller has a Hw Id of 41 or 75, you do not need to perform the Replace Front End
Controller procedure.
— If the analyzer has N9010B-DP2, N9010B-MPB, N9020B-DP2, and/or N9020B-MPB
installed, verify that it also has a Front End Controller with Hw Id of 75 or 170 and a Digital
IF with Hw Id of 34. If any of the listed options is present and the Front End Controller has
Hw Id of 75 or 170 and the Digital IF has Hw Id of 34, all the necessary hardware is already
installed. It is only necessary to redeem the license entitlement for B40 and perform the
necessary adjustments and performance verification tests.
Installation Note N9020-90253
Part # Matl Rev Rev OF Rev
Installation Procedure
Hw Id
9