Keysight Technologies N9010B EXA Installation Note page 28
Mxa signal analyzer option b40, 40 mhz analysis bandwidth and microwave preselector bypass (mpb) upgrade kit
Hide thumbs
Also See for N9010B EXA:
- Installation note (35 pages) ,
- Installation notes (27 pages) ,
- Getting started and troubleshooting manual (91 pages)
Table of Contents
Advertisement
Installation Procedure
10.Locate the switch control cable harness (E4410-60159) in the kit.
11.Refer to
Figure
16. Connect the end of the switch control harness with only one connector to
J801 on the A15 Enhanced Front End Control Assembly.
Figure 16
Wire Harness Routing
12.Connect the remaining two wire harness connectors (1) to the switches. Once connected,
position the connections along side the switches.
13.Connect ribbon cable W18 to J4 of the A11 Low Band Switch.
28
Installation Note N9020-90253
Advertisement
Table of Contents
