Keysight Technologies N9010B EXA Installation Note page 51

7. The FPGA Programming Utility will start and a window as shown in
Figure 37 FPGA Programming Utility
8. To program the FPGA code, press 1 on the numeric keypad and press Enter. You will need to
confirm this selection by pressing 1 and Enter one more time.
9. The programming of the FPGA code could take several minutes to complete. Once it has
finished the instrument will reboot itself and use the new code and this process will then be
completed.
Installation Note N9020-90253
Installation Procedure
Figure 37 will appear.
51