Keysight Technologies N9010B EXA Installation Note page 32

Mxa signal analyzer option b40, 40 mhz analysis bandwidth and microwave preselector bypass (mpb) upgrade kit

Hide thumbs Also See for N9010B EXA:

Table of Contents

Installation Procedure

19.Refer to

Figure

20. Locate W33 semi-rigid coax cable (E4410-20165) in the kit. Connect the

cable between port 2 of Switch 1 (the lower switch) and the output of the A12 YTF Preselector.

Torque the cable at the A12 end first to 10 inch-pounds and then torque the cable at the

Switch 1 end to 10 inch-pounds.

20.Locate W32 semi-rigid coax cable (E4410-20163) in the kit. Connect the cable between port 2

of Switch 2 (the upper switch) and the input of the A12 YTF Preselector. Torque the cable at

the A12 end first to 10 inch-pounds and then torque the cable at the Switch 2 end to

10 inch-pounds.

Figure 20

Install W33 and W32

Installation Note N9020-90253

Table of Contents

N9020b