Installing Microwave Preselector Bypass Switches
1. Refer to
Figure
13. Remove the ribbon cable W18.
Figure 13
Low Band Switch Removal
2. Remove the semi-rigid cables W3 and W8 using the 5/16 inch wrench. W8 will not be used
after the preselector bypass switches are installed.
Installation Note N9020-90253
Perform this procedure only if the analyzer has frequency range Option 507, 508. 513, or 526. If
the analyzer has frequency range Option 503, skip to the
on page
33.
Installation Procedure
"Replace A3 Digital IF Assembly"
25