Keysight Technologies N9010B EXA Installation Note page 31
Mxa signal analyzer option b40, 40 mhz analysis bandwidth and microwave preselector bypass (mpb) upgrade kit
Hide thumbs
Also See for N9010B EXA:
- Installation note (35 pages) ,
- Installation notes (27 pages) ,
- Getting started and troubleshooting manual (91 pages)
Table of Contents
Advertisement
17.Refer to
Figure
19. Locate W34 semi-rigid coax cable (E4410-20164) in the kit. Connect the
cable between the center port of Switch 1 (the lower switch) and J9 of the A13 Front End
Assembly. Torque to 10 inch-pounds.
18.Locate W31 semi-rigid coax cable (E4410-20161) in the kit. Connect the cable between the
center port of Switch 2 (the upper switch) and J3 of the A11 Low Band Switch. Torque to
10 inch-pounds.
Figure 19
Install W34 and W31
Installation Note N9020-90253
Installation Procedure
31
Advertisement
Table of Contents
