Setting With Engineering Tool - Toshiba V Series User Manual

1.8.4

Setting with Engineering Tool

Use the Engineering Tool for setting parameters in an EN5 module.
Confirmation of network parameters
Set network parameters for the network where an EN5 module is connected.
When "Set from Tool" is selected for IP address type setting, start the Engineering Tool
and register them, taking the following steps.
For detailed information on the Engineering Tool, see "Engineering Tool - User's Manual".
Here, the engineering of the EN531 based on the configuration shown in Figure 1-27 will
be discussed.
Confirm the following before setting any parameters using Engineering Tool that all the
operation mode switches are in the OFF position.
•
•
6F8C1005
MainSlotNo：
P
S
5
9
Controller A
1
Line
A
Figure 1-27 Example of System Configuration
All the "Operation mode switches" are set to OFF.
The Host ID setting switches H and L are set to 0 and 2 (the latter in decimal),
respectively.
Engineering tool
1
0
L
E
1
N
P
5
U
3
' MainUnit '
1
1
1
H
192.0.0.2
Note) Subnet mask: 255.255.255.192
1.8 Setting Ethernet Module
192.0.0.1
59
1