Toshiba V Series User Manual page 42

Chapter 1 Overview
1
26
Table 1-24 Signal Arrangement on Terminal Block
Pin No. Signal
1 FG
2 P24(+24V)
3 COM(0V)
4 WDTOUT
5 COM(0V)
6 N.C.
7 N.C.
8 MON485(+)
P24(+24V) : Connect the (+) wire of an external power supply (24 VDC).
COM(0V) : Connect the (-) wire of an external power supply (24 VDC).
WDTOUT : WDT (watchdog timer) output
MON485(+) : Connect the (+) wire of LD512H or RS-485 for graphic panel.
MON485(-) : Connect the (-) wire of LD512H or RS-485 for graphic panel.
IOBUS(+) : Can be connected to the (+) wire of an IO bus.
IOBUS(-) : Can be connected to the (-) wire of an IO bus.
TIMER IN : Power failure timer input
N.C. : Leave the pins unconnected.
Pin No. Signal
9 MON485(-)
10 IOBUS(+)
11 IOBUS(-)
12 TIMER IN
13 N.C.
14 N.C.
15 N.C.
16 N.C.
model 1000 Loop Controller L1 User's Manual - Basic Hardware