Lp03 Hardware Specifications - Toshiba V Series User Manual

A.6 LP03 Hardware Specifications
Input
Output
IOBUS
Front panel
Retentive power interruption
Insulation resistance
Withstand voltage
Power supply
Current
consumption
Rush current
LP01 swap
Operating
environment
Installation
Weight
External dimensions
External connection
Environmental
conditions for
accuracy
6F8C1005
Table A-17 LP03 Hardware Specifications
Item
Analog input • 1 to 5 VDC at 4 points
Accuracy: ± 0.2%
Input resistance: 1 MΩ or higher (including the resistance at
power off)
Input break detecting function: Down scale
Digital input • Non-voltage contacts: 3 points
Input current: 5 mA (External power supply 24 VDC, contact
resistance 0 Ω)
Contact resistance: ON 200 Ω or less
OFF 100 Ω or higher
Operation output (LP03) • DC 4 to 20 mA at one point
Load resistance; 0 to 600 Ω
Accuracy ± 0.3%
Analog output • 1 to 5 VDC at 2 points
Load resistance: 5 KΩ or higher
Accuracy ± 0.2%
Digital output • FET open drain output at 3 points
Load current: Max. 100 mA (resistance load)
Rated voltage: 24 VDC
Physical layer RS-485 1 point
Transmission rate 19.2 Kbps
Communication Half-duplex, asynchronous, multi-drop
Transmission distance Max. 100m (twisted pair, shielded cable)
RUN LED (green) ON Operating normally
OFF WDT triggered, ROM/RAM error, 24V power drop
ALM LED(red) ON Initializing
OFF Operating normally
Rotary switch I/O address (0 to F)
1ms (reference value)
As measured with a 500 VDC megger
100 MΩ or higher (between input and power supply)
100 MΩ or higher (between input and FG)
100 MΩ or higher (between output and FG)
500 Vrms, 1 minute (between input and power supply)
500 Vrms, 1 minute (between input and FG)
500 Vrms, 1 minute (between output and FG)
LP01 unit 24 VDC + 10%, -15% (supplied from power unit terminal)
DI/DO 24 VDC + 10%, -15% (supplied from the terminal block of this
unit)
LP01 unit About 150 mA (at 24 VDC)
DI/DO About 40 mA
Max. 5Ap-p
Hot swap possible
Operating temperature
0 to 55
Humidity 10 to 90%RH (with no condensation)
Storage temperature
-25 to 70
Mounting on DIN rails 35 mm wide (Depth of DIN rail: 15 mm or
more)
LP01 unit About 220 g
Terminal block About 220 g
160H × 60W × 110D
M3 screw terminal (12P × 2)
Power supply voltage 24.0V
Ambient temperature o
25 C
A.6 LP03 Hardware Specifications
Specifications
o
C
o
C
A
113