Toshiba V Series User Manual page 76

Chapter 1 Overview
1
60
Set as follows:
(1) Start the Engineering Tool.
(2) Start the Configuration Editor [Hardware Configuration] of Controller A.
The screen where the hardware configuration of Controller A is registered is
displayed.
For registering hardware configuration, see "Engineering Tool - User's Manual".
Figure 1-28 Hardware Configuration Screen
(3) Select EN531, and execute [Edit (E)] and [Set Parameters (P)].
The screen shown below will be displayed.
Figure 1-29 EN531 Parameter Window (1)
model 1000 Loop Controller L1 User's Manual - Basic Hardware