Toshiba V Series User Manual page 35

(1) LED indicators
LED
RUN
HLTH
LINE
(2) Setting switches
Before mounting an EN531 module in the terminal block unit, set the switches
determining the host ID of the EN531 module and its operation mode. These
switches are provided on the front of the EN531.
The setting procedures are as follows:
1 Host ID switches
On the front, there are hexadecimal rotary switches, which set a host ID to determine
its Ethernet IP address. Set an address in hexadecimals (1 to 62) within the range
allocated during system configuration. Allocate a different value to each node in the
system. Use a small slotted screwdriver to set them.
Use a small slotted screwdriver to set these values.
Name
Host ID
2 Setting switches
On the front, there are 4-bit DIP switches that determine the operation of the EN531
module. Use a small slotted screwdriver for setting these switches.
Table 1-18 shows a description of each switch.
The host ID setting hexadecimal rotary switch used to set an Ethernet IP address, is
provided on the front. Set an address in hexadecimals (1 to 62) within the range
allocated during system configuration. Allocate a different value to each node in the
system. Use a small slotted screwdriver to set them.
6F8C1005
Table 1-16 LED Indications on EN531
Station status
Module normal
Ethernet transmission status
Table 1-17 Host ID Setting
Location
Set value: 01 to 3E(h)
STNH H (H address): 0 to 3(h)
STNL L (L address): 0 to F(h)
1.6 Names and Roles of Products
Meaning
Setting Initial setting (factory setting)
00(h)
or
the value determined for the system
Color
Green
Green
Green
19
1