Batteries - Kane 456 Manual

1.

BATTERIES

Battery Type
This analyser has been designed for use with disposable alkaline batteries or
rechargeable Nickel Metal Hydride (NiMH) batteries. No other battery types are
recommended.
WARNING
The battery charger unit must only be used when NiMH batteries are fitted. Do
not mix NiMH cells of different capacities or from different manufacturers. All
four cells must be identical
Replacing Batteries
Turn over the analyser, remove its protective rubber cover and fit 4 "AA" batteries in
the battery compartment. Take great care to ensure they are fitted with the correct
battery polarity. Replace the battery cover and protective rubber cover.
Switch the analyser on and check that the analyser's time and date are correct. To
reset see USING THE MENU, Section 5.
Charging NiMH Batteries
Ensure that you use the correct charger. The part number is 19278.
To fully charge NiMH batteries:
The charger must be connected and switched on.
When charging, the red Battery Charging Indicator will illuminate.
After a few seconds, the display will show " CHARGING BATTERY" if they need
extra charge.
The first charge should be for 12 hours continuously. NiMH batteries are suitable for
top up charging at any time, even for short periods.
An in-vehicle charger can be used to top up the analyser's batteries from a 12 volt
vehicle battery. The part number is 18342.
Battery Disposal
Always dispose of depleted batteries using approved disposal methods that protect the
environment
Page 7