Table of Contents
Advertisement
Chapter 4 Device Remote Operation
For properly running the system, set a login password to activate the panic alarm station before the first use.
You can activate the device via SADP or client software.
The factory settings are show as follows.
IP address: 192.0.0.65
Port No.: 8000
Admin User NameP: admin
4.1
Device Management
Purpose:
In this section, you are able to configure or view the basic parameters (such as the system information, alarm information, network
data, device status and so on) of the device.
4.1.1
Add a Device
Steps:
1.
Click the
icon on the control panel to enter the Device Management interface and click the Server tab.
2.
Click Add New Device Type on the Organization list and select Security Control Panel.
3.
Click OK to save the settings, and the added security control panel type is displayed on the Organization list.
4.
Click Security Control Panel and click Add Device to add the device to the management list of the software.
5.
You can add the active online devices in the same local subnet with the client software, or select the adding mode by
IP/Domain Name, by IP segment, by IP Server, or by HiDDNS, and configure the corresponding settings for the device. Take
IP/Domain Name as an example.
Panic Alarm Station User Manual
18
Advertisement
Table of Contents
