Mitsubishi 800 Series User Manual page 89

5. Handling Component Equipment Modules MELSEC GOT
5.4.4
Instatling a network module
This shows how to install a network module in the GOT. For more detailed information on network
module specifications and settings, please refer to the A7GT-J71 LP23/BR13 User's Manual and
the MELSECNET/lO Network System Reference Manual (For PC Networks).
1
DANGER
0 Before installing a network module in the GOT, or removing a module already in-
stalled, switch all phases of the external power supply off to the GOT.
I
Reverse surface of GOT
I
Netw
Reverse surface
of
network
module
*
STATION
Network unit LED section
@ Install the network module to the GOT, then fix
it in place by
tightening the screws of the network module within the range
of specified torque, 39 to 59 N c m (4 to 6 kgcm).
To remove the network module, loosen the screw, and then
reverse the installation procedure.
@
Connect the link cable to the network module.
For instructions on connecting a coaxial cable, please refer to
the MELSECNET/lO Network System Reference Manual (For
PC Networks).
@ Set the mode change switch of the network module to the
Test Mode.
@ Turn on the power supply to the GOT and run a link test of the
network.