Mitsubishi 800 Series User Manual page 111

9.
Installation M€LS€C GOT
The module is made of resinous materials, and should be protected
from strong
shock or
impact.
Do not separate the PCB of the module from the case, as this can result in a breakdown.
When attaching the main module to the control panel, position the display module as shown
below.
9
If the temperature inside the panel is 55"C, the display module should be attached at an
angle within the range of 60 to 105".
4
GOT
Display
module
Panel
/ '
Using the display module at an angle outside the range noted above may cause the GOT to
wear out faster than it would otherwise. Make sure the temperature inside the panel does
not exceed 40°C.
9 - 2