Mitsubishi 800 Series User Manual page 86

5. Handling Component Equipment
Modules
MELSEC GOT
5.4.3 Installinga
data
+ l i n k
e n d u b . .
This shows how to install a data link W u l e in the GOT. For more detailed information on data link
module specifications and settings, please refer to the A7GT-J71AP23/R23 User's Manual, the
A7GT-J71AT23B User's Manual, and the MELSECNFT and MELSECNET/B Data Link System
Reference Manuals.
1
@
DANGER
0 Before installing a data link module in the GOT, or removing a module already in-
stalled, switch at 1 phases of the external power supply off to the GOT.
Reverse surface of GOT
~~
lata link module
Ditch
Reverse surface
of data link
module
Data link module LED
@ Install the data link module to the GOT, then
fix it in place by
tightening the screws of the data link module within the range
of specified torque, 39 to 59 N c m (4 to 6 kgscm).
To remove the data link module, loosen the screw, and then
reverse the installation procedure.
@ Connect the link cable to the data link module. For instructions
on connecting a coaxial cable or twisted pair cable, please re-
fer to the MELSECNET and MELSECNET/B Data Link System
Reference Manuals.
@
Set the mode change switch
of
the data link module to the
Test Mode.
@
Turn on the power supply to the GOT and run a test of the data
link.
5 - 9