IO.
Maintenance and Inspection
MELSEC GOT
._
Holding
the
connector,
tip
@
it slightly toward the @
Pressing on the backlight
side,
and
pull it upwards, in
fitting at @ with a finger,
direction @,
pull
it
in direction @.
.
TFT-type
/
Push
up the
catch (black) that is holding the back-
light in the
@
direction and then pull it out in the @
direction.
Remove the backlight cable connector
from
the dis-
play unit connector.
(5) Install the new backlights by reversing the above procedure, and fit the display module back
into its case.
Point
Securing screws should be tightened to a tightening torque of 39 to 59 N c m (4 to 6 kgcm).
L
I
1 0 - 4