Epson RC420 Manual page 168

Maintenance 12. Recovering the HDD
(3) Click the <Next> button in the [Welcome to the Add/Remove Hardware Wizard]
(4) Select the <Add/Troubleshoot a device> option button in the [Choose a Hardware
(5) Select the "Add a new device" in the [Choose a Hardware Device] dialog. Click
(6) Select the <No, I want to select the hardware from a list> option button in the [Find
(7) Select the "SPEL RESOURCE Drivers" in the [Hardware Type] dialog. Click the
(8) Select the applicable Models for each option in the [Select a Device Driver] dialog.
(9) Another dialog appears. Click the <OK> button.
(10) Click the <OK> button in the [Add New Hardware Wizard Properties] dialog.
(11) Click the <Yes> button in the [Creating a Forced Configuration] dialog.
(12) Click the <Next> button in the [Start Hardware installation] dialog.
(13) Click the <Finish> button in the [Completing the Add/Remove Hardware Wizard]
(14) When you continue reserving address resources of the EPSON RC+ options, click
After setting up EPSON RC+, set up UPS and restore the back-up data. For details,
NOTE
refer to the Setup & Operation 10.6 Configuring Windows and Maintenance 2.5 Backup
of Data.
158
dialog.
Task] dialog. Click the <Next> button.
the <Next> button.
New Hardware] dialog. Click the <Next> button.
<Next> button.
Click the <Next> button.
Expansion I/O Board
Pulse Generating Board : SPEL RESOURCE PG *
dialog.
the <No> button in the [System Setting Change] dialog and repeat the same steps
from (2) for each option.
When you finish reserving address resources of the EPSON RC+ options, click the
<Yes> button in the [System Setting Change] dialog and restart Windows.
: SPEL RESOURCE IO *
(The asterisk * indicates each board number.)
RC420 Rev.9