Epson RC420 Manual page 113

[For users who use the RC420 Controller with UPS]
The RC420 Controller is configured at factory as shown below:
Computer Name SN***** (Serial No.*)
User Name
Password
* Serial No. (SN*****)
: ***** denotes a five-digit number and it is unique to each Controller.
When the computer name, user name, or password is changed, the UPS will not
automatically shut down the RC420 Controller in the case of a power failure despite its
setting.
After you change the computer name, user name, or password, configure the UPS again
so that it will automatically shut down the RC420 Controller in the case of a power
failure. For details, refer to the section 10.6.3 Setting up the Automatic Shutdown at the
Time of a Power Failure.
RC420 Rev.9
Setup & Operation 10. UPS (Uninterruptible Power Supply)
EPSON RC+4.1 or before
(Windows 2000)
Administrator
Not set
EPSON RC+4.2 or after
(Windows XP)
Computer Name SN***** (Serial No.*)
User Name EPSON RC User
Password epson
103