Configuring Windows; Setting Up Epson Rc+ (Using The Network); Necessary Items; Sharing Configuration - Epson RC420 Manual

12.2 Configuring Windows

(1) Double-click the <My Computer> - <Control Panel> - <System> icons.
(2) Select the [Advanced] tab in the [System Properties] dialog, and click the <Startup
(3) Uncheck the [Automatically reboot] check box in the [System Failure] group box in
(4) Another dialog appears. Click the <OK> button.
(5) Click the <OK> button in the [System Properties] dialog.
(6) Click the <No> button in the [System Settings Change] dialog.
Following items are set up by Windows recovery.
NOTE
- Change the display configurations
- Power configurations
- Setting the Network to disabled
- Disabling the Check Disk during Windows start
- Changing the Communication Port COM3 configuration
- Disabling the automatic update
12.3 Setting Up EPSON RC+
This section describes the easiest procedure for setting up EPSON RC+ with "NetBEUI"
protocol using the network.
Prepare the following items for the EPSON RC+ installation.
EPSON RC+ Setup CD-ROM
PC connected to the network with the
magneto-optical disk drive that is
available for CD-ROM read
Network cable
Set the CD-ROM drive on your PC to "Sharing" following the procedure below.
(1) Start Explore and select the "CD-ROM drive".
(2) Select the [File] - [Properties].
(3) Select the [Sharing] tab and select the <Share this folder> option button.
(4) Click the <OK> button.
RC420 Rev.9
Disabling the Automatic Restart at System Error
and Recovery> button.
the [Startup and Recovery] dialog. Then, click the <OK> button.

12.3.1 Necessary Items

Items

12.3.2 Sharing Configuration

Maintenance 12. Recovering the HDD
(Using the Network)
Attachment to RC420
OS:
Windows 95, Windows 98, Windows NT,
Windows 2000, Windows XP
For cross cabling
Note
151