Configuring The 1769Sc-Ir6I - Spectrum Controls 1769 User Manual

Appendix D: Configuring the IR6I to be Used with a 1769-AND DeviceNet Adapter
Configuring
the 1769sc-IR6I
To configure I/O for the adapter, double-click on the adapter that you just placed
on the network, and the following screen appears:
At this point, you may modify the adapters DeviceNet node address, if desired.
Next, click on the Module Configuration tab. The following screen appears:
The 1769-ADN appears in slot 0. Your I/O modules, power supplies, end cap
and interconnect cables must be entered in the proper order, following the 1769
I/O rules contained in the 1769-ADN user's manual. For simplicity sake, we
placed the 1769sc-IR6I in slot 1 to show how it is configured. As a minimum, a
power supply and end cap must also be placed after the 1769sc-IR6I module. To
add the 1769sc-IR6I to bank 1, click on the first empty slot after the 1769-ADN.
From the module list on the left, select the 1769sc-IR6I. The module should
User's Manual Pub. 0300241-02 Rev. A
D-3