Pneumatic Ports 1 And 2; Pneumatic Port - Festo MS6-SV Operating Instructions Manual

MS6−SV

Pneumatic ports 1 and 2

If using screw connectors with width across flats larger than A/F24:
Remove the MS6−END cover cap, if fitted (push upwards).
S
If using screw connectors:
Note the maximum permitted screw−in depth of the connector threads:
S
Type
MS6(N)−SV
For larger screw−in depths, it is necessary to use MS6−AG /AQ sub−bases
from Festo.
Make sure that the compressed air tubing is connected correctly.
S
Screw the connectors into the pneumatic ports using suitable sealing material.
S

Pneumatic port 3

Exhausting a system using the MS6−SV results in high levels of noise. We therefore
recommend that you use a silencer.
Warning
If a commercially−available silencer is used, the body of the silencer may
become clogged, which can result in reduced exhaust performance (back
pressure).
S Use the safety silencer designed for the device (è Chapter 11 Accessories").
S Only use a commercially−available silencer if it will be maintained at regular
intervals by service staff and if also using a back pressure monitoring system.
Screw the silencer into pneumatic port 3.
S
Make sure that there is unrestricted exhausting. Neither the silencer nor port 3
S
should be blocked.
34
Max. screw−in depth [mm]
ISO 228 (NPT)
10.0 10.0
Festo MS6−SV 0706NH English