Safety Conditions - Festo MS6-SV Operating Instructions Manual

MS6−SV
3

Safety conditions

The MS6−SV was developed and produced in careful compliance with the relevant
norms and directives, as well as the approved technical rules. However, the de
vice's protective function can be impaired if the device is not used as intended.
This could endanger the lives and physical condition of persons.
Installation and commissioning
The device must only be installed and commissioned by trained specialists.
The MS6−SV must only be connected and operated using the values specified in
Chapter 13, Technical data".
Warning
The use of impermissible media can damage the product.
S Do not use the MS6−SV together with inflammable gases or acid. The device
is only intended for use with media listed as appropriate in the technical
data.
Remove all transport packing such as protective wax, foils (polyamide), caps
S
(polyethylene), cardboard boxes (except for the sealing elements of the pneu
matic connections).
The packing is intended for recycling (except for: oiled paper = other waste).
Check the device for damage caused during transport. Only install undamaged
S
devices in their original condition.
Remove dirt particles in the supply lines by blowing through the tubing and
S
hoses. In this way you will protect the MS6−SV from premature failure or heavy
wear (see DIN ISO 4414, section 9.4).
30
Festo MS6−SV 0706NH English