Installation Guide for RFU-D-HP
6
Plug the power cable with connector into the PWR port.
7
Screw the gland into the radio unit
Important Note!
the gland gently and make sure there is no resistance. If there is resistance, stop immediately and
verify that the gland is not being inserted at an angle. Tightening the gland at an angle can ruin the
thread on the gland and prevent proper sealing of the interface.
8 Tighten the gland cap.
9 Secure the cable to the gland with a tie wrap.
Before tightening the gland, make sure the gland is even with the cover. Tighten
Page 54 of 179