Antenna Connection - Cambium Networks PTP 820 Series Installation Manual

Installation Guide for RFU-D-HP

Antenna Connection

RFU-D-HP can be mounted directly for 6 to 11 GHz using the following antenna types (for integrated antennas, specific
antennas are required):
•
CommScope: VHLP series
•
Radiowave: HP Series
For remote mount installations, the following Flexible Waveguide flanges should be used (millimetric). The same
antenna type (integrated) as indicated above can be used (recommended).
Other antenna types using the flanges listed in the table below may also be used.
Frequency Band
6(L/U) GHz
7/8 GHz
10/11 GHz
If a different antenna type (CPR flange) is used, a flange adaptor is required. Please contact your Cambium Networks
representative for details.
Note!
Appropriate lubricant or grease can be applied to the screws that connect the RFU-D-HP to the
antenna interface.
1
There is no direct WG connection. An adaptor is required to connect the RFU to the WG.
Table 3: Antenna Flanges
Range (GHz) Rect. WG Flange Des. Radio Side (Remote) Flange Des.
5.8-7.1 WR137
7.1-8.5 WR112
10.0-11.7 WR90
Page 27 of 179
1
UDR70
1
UBR84
1
UBR100