Cambium Networks PTP 820 Series Installation Manual page 150

Installation Guide for RFU-D-HP
4 RFU-D- 2 See Section Error! Reference source not found., Error! Reference source not found.
HP OCU
Kit
5 RFU-D- 2 FXDH-RM-TERM-06
HP FXDH-RM-TERM-7-8
Terminat FXDH-RM-TERM-11
ion Kit
6 RFU-D- 2 FXDH-RM-U-Bend-06
HP FXDH-RM-U-Bend-7-8
Branchin FXDH-RM-U-Bend-11
g Short
U-Bend
Kit
7 RFU-D- 1 DXDH-MD-OMT-ff
HP OMT
Kit
8 Flexible 2
Wavegui
des
Procedure
1 Assemble the OCU Mounting Kit. See Section Chapter 0, Assembling the OCU Mounting Kit.
2 Assemble an OCU using a Left Rail Configuration, attach the an RFU-D-HP radio to the OCU, and connect
the radio-OCU assembly to the Branching Pole Profile. See Section Chapter 0, Assembling the OCU.
3 Assemble the second OCU using a Right Rail Configuration, attach the second RFU-D-HP radio to the
OCU, and connect the radio-OCU assembly to the Branching Pole Profile. See Section Chapter 0,
Assembling the OCU.
3 On the side of the OCU facing the pole, attach Short U-Bends between the radio ports of the two OCUs.
See Section Chapter 0, Assembling a Short U-Bend.
4 Connect the OMT to the antenna. See Steps 1-4 in Section Chapter 0, 2+0 Dual Polarization Remote
Mount.
5 On the side facing away from the pole:
o
Connect flexible waveguides from both radio ports of the OCU on the left to the OMT.
o
Connect Terminations to both radio ports of the OCU on the right. See Section Chapter 0, Assembling a
Termination.
Page 150 of 179