Cambium Networks PTP 820 Series Installation Manual page 116

Installation Guide for RFU-D-HP
2 Mount and tighten the RFU-D-HP Remote Mount Adaptor plate (supplied in the RFU-D-HP Adaptor
Remote Mount kit) to the RFU-D-HP Pole Mount using the four flat screws supplied with the RFU-D-HP
Adaptor Remote Mount kit. See Steps 0 and 0 in Section Chapter 0, 2+0 Dual Polarization Remote
Mount.
3 Mount and tighten the RFU-D-HP Dual Circulator/Splitter to the RFU-D-HP Pole Mount using the four
screws and washers that are supplied with the RFU-D-HP Dual Circulator/Splitter kit. Make sure that the
O-rings are mounted on the RFU-D-HP Remote Mount Adaptor.
4 Attach the Diplexer unit to the Dual Circulator/Splitter using 8 M4 screws provided with the Diplexer kit,
as shown below, using 20Nm torque.
Page 116 of 179