Cambium Networks PTP 820 Series Installation Manual page 165

Installation Guide for RFU-D-HP
Procedure
1 Assemble the OCU Mounting Kit. See Section Chapter 0, Assembling the OCU Mounting Kit.
2 Assemble two OCUs, both using a Left Rail Configuration. Attach an RFU-D-HP radio to each OCU, and
connect the radio-OCU assemblies to the Branching Pole Profile as shown in the following figure. See
Section Chapter 0, Assembling the OCU.
Left
3 On the side of the OCU facing the pole, attach a Termination to each of the four radio ports. See Section
Chapter 0, Assembling a Termination.
4 On the side facing away from the pole (refer to the numbering in the figure above):
o
Connect a Coupler to the upper radio port of OCU 1. See Section Chapter 0, Assembling a Splitter or Coupler for
Filter-Based Branching
o
Connect a flexible waveguide from the Coupler to the upper radio port of OCU 2.
o
Attach a Termination to each of the lower radio ports. See Section Chapter 0, Assembling a Termination.
(1)
.
Page 165 of 179
Left
(2)