Troubleshooting Vlan Configuration And Switching; Troubleshooting A Configuration Failure - Avaya 2330/4134 Troubleshooting Manual

Troubleshooting a Data Link Layer problem
• For untagged multicast and unicast packets use the show interface
<interface> command to check the Rx/Tx packets on both ingress and egress ports.

Troubleshooting VLAN Configuration and Switching

Use the following commands to create VLANs in the bridge global database. The created
VLANs have to functionally or characteristic unless used in an interface.
/configure# vlan database
/configure/vlan# vlan <vid> [name <WORD>]
To bind a VLAN to an interface use the following command:
/configure/interface/ethernet (5/1)#switch trunk allow vlan 10

Troubleshooting a configuration failure

Assigning a VLAN to an interface fails
• VLAN may not be created in the VLAN database yet. Use the show bridge vlan to
verify.
90 Troubleshooting
Comments? infodev@avaya.com
August 2013