LED color
Green
No dial tone on the analog FXS phones or ports
The dial tone is only played on the FXS ports after the voice ports have been configured and
enabled.
To display the status of the voice ports on the system, use the show voice port
summary command.
Figure 70: show voice port summary sample output
Unable to make FXS calls
If you are unable to make FXS calls, refer to the following sections for troubleshooting.
Verify that the port and dial peer are enabled
Make sure the port is not shut down using the show voice port summary command.
Figure 71: show voice port summary sample output
Make sure the dial peer is configured with the appropriate destination pattern and is not shut
down using the show dial-peer voice summary command.
Troubleshooting
Busy; Call in Progress
Common problems and solutions
Description
August 2013
333