Precautions For Use - Sekonic SR-2300 Manual

Precautions For Use

Handle the device with the following points in mind to enable full use of its functions.
• Precautions regarding installation
Do not place the device in the following places. Otherwise, failures could result such
as paper jams, reading errors, or the unit could become inoperative.
(1) In direct sunlight or near a heating device.
(2) Outdoors where the main body may not perform satisfactorily due to rain or
strong wind.
(3) A place where the main body may not perform satisfactorily such as it is
subject to vibration while operating, or it is placed in an unstable location.
(4) Places subject to sudden temperature changes, excessive moisture and dust.
Recommended temperature: 10-30°C
Guaranteed operating temperature range: 5-35°C
Humidity: 30-80%
Avoid environments outside the above ranges as much as possible when
placing the device.
• Handling precautions
(1) Do not connect or disconnect the power cord or connector when the device
is operating or the power switch is on.
(2) Do not move the device while it is operating. Also, do not touch, pull, or push
paper.
(3) Do not put objects on the device, or sit or lean on it.
(4) Do not give the device a strong shock.
(5) Allow an interval of at least 5 seconds between turning the power switch on
and off.
(6) Do not insert foreign objects other than paper.
(7) Do not apply force that deforms paper while it is being loaded.
(8) Since the paper reading part is equipped with an optical lens, never insert a
screwdriver or other such objects. (Otherwise, reading may be disabled.) If
paper feeding is disabled due to dust or the like in the paper feeder, open the
top cover to remove it. (
(9) If the paper-feeding roller becomes soiled with powder from paper or pencil
lead, the roller and the paper may slip. In order to prevent slippage, clean the
paper-feeding roller at proper intervals. (
(10) If the exterior of the device is soiled, lightly wipe with a soft cloth wetted with
water or a neutral detergent. Note that wiping with a cloth wetted with volatile
chemicals like benzene or paint thinner may cause deformation or discoloring.
"Cleaning" p.48)
S e e
"Cleaning" p.48)
S e e
Precautions For Use
-9-