B Setting Density Balance - Sekonic SR-2300 Manual

B
Setting density balance
You can set the density balance level when using the SR-600 operating mode.
Density balance can be set so that when marks are read, marks lighter than the set density
balance will be ignored, and marks darker than the set density balance will be detected. Density
balance can be set from 1 to 15.
1.
MENU
Press the
2.
UP
Use the
and press the
3.
UP
Use the
and press the
(" " mark flashes in the first column of the first line on the LCD.)
4.
UP
Use the
5.
FEED/ENTER
Press the
(The flashing " " mark disappears from the LCD.)
6.
Keep pressing the
or press the
Data reading settings
switch to enter the menu mode.
DOWN
and switches to select the following parameters,
FEED/ENTER
switch.
DOWN
and switches to select [Density Balance] setting,
FEED/ENTER
switch.
DOWN
and switches to set the value.
switch to save the setting value into memory.
CLEAR/EXIT
switch until it returns to normal mode,
C
MENU
switch to return to normal mode.
B
Setting density balance
Density balance
setting values
1 - 15
-31-