B Loading Paper - Sekonic SR-2300 Manual

B
Operation Loading paper
B
Loading paper
1.
Load paper with the timing marks on the left side of the hopper. The hopper is set to
drop when the power is turned on, but if it's still raised, press the DOWN switch in
normal mode to lower the hopper. At this time, align paper carefully. Pay particular
attention to the leading edges of the paper because feeding errors may occur unless
the paper is properly aligned.
2.
Press the side guide firmly onto the paper so there is no gap, otherwise reading
errors may occur. When moving the side guide, keep pressing the guide lock lever
(green). The side guide is fixed when the lever is released.
Timing mark
3.
To see the maximum number of cards that can be loaded into the hopper, refer to the
side guide index. (A maximum of 500 sheets of 105g/m
overloading may result in paper not feeding, or in reading errors.
Notes)
1) Carefully handle paper so that it is not bent or damaged. If bent or
damaged sheets are used, paper may not feed or reading errors may
occur.
2) Do not use paper in any of the following states:
Soiled or damaged paper, paper to which dust or other foreign matter
adheres, curled paper or folded paper (folded in two, four, etc.)
3) When adding paper, lower the hopper and be sure to reset the paper.
Before using new paper to test paper feeding, be sure to loosen the
sheets as shown in the left figure so as to prevent double feeding when
sheets adhere to each other.
4) When storing paper, avoid keeping it in a place subject to sudden
environmental changes. Pay thorough attention to moisture and keep
paper in a cabinet or other safe place. Do not leave paper in a dusty
place such as near a window.
-16-
Guide lock lever
Note)
When using paper other than IBM
card size, set the paper-feeding
auxiliary bracket at the bottom
end of the paper.
Side guide
2
weight paper.) Note that