Sekonic SR-2300 Manual page 56

Error displays and countermeasures
(3) Operating errors
Hopper stops
Drawing out error
Timeout
Timing mark error
White level error
Black level error
Form left in hopper
Form left in
reading-sensor
Form left in
end of main body
-56-
Error Explanation
Interlock on the side of the
paper-feeding roller operated.
Sheet was pulled out after it was fed.
A sheet wasn't fed within the set sheet
insertion duration.
Only three or fewer timing marks were
detected on the front surface of the read
sheet.
Only three or fewer timing marks were
detected on the back surface of the read
sheet.
There is dark colored stain on the front
surface reading unit.
There is dark colored stain on the back
surface reading unit.
There is light colored stain on the front
surface reading unit.
There is light colored stain on the back
surface reading unit.
Error Explanation
A sheet remained in the paper feeding
detection sensor.
A sheet remained in the reading start
detection sensor.
A sheet remained in the main body
paper discharge detection sensor.
Front surface reading sensor
• Release the interlock switch.
• Press the CLEAR switch
(or execute the clear error
command).
Press the CLEAR switch
(or execute the clear error
command).
Press the CLEAR switch
(or execute the clear error
command).
Press the CLEAR switch
(or execute the clear error
command).
Press the CLEAR switch
(or execute the clear error
command).
Press the CLEAR switch
(or execute the clear error
command).
• Remove the remaining sheet.
• Press the CLEAR switch
(or execute the clear error
command).
• Remove the remaining sheet.
• Press the CLEAR switch
(or execute the clear error
command).
• Remove the remaining sheet.
• Press the CLEAR switch
(or execute the clear error
command).
Interlock
Paper feeding detection sensor
Reading start detection
sensor
Back surface reading sensor
Main body paper discharge
detection sensor
Solution
Solution