Otto Bock 4WR95-2 Instructions For Use Manual page 25

Single-component pack
4D27 contains:
4 M8x10 corrosion protected set screws
8 M8x12 corrosion protected set screws
8 M8x14 corrosion protected set screws
4 M8x16 corrosion protected set screws
2 M5x22 corrosion protected cylinder head screws
2 rounded washers
1 M5x30 corrosion protected cylinder head screw
1 plastic ring
3 cm shrink tubing
7 Disposal
7.1 Disposal Information
INFORMATION
These products may not be disposed with household waste in
some jurisdictions. Disposal that is not in accordance with the
regulations of your country may have a detrimental impact on
health and the environment. Please observe the information
provided by the responsible authorities in your country regar-
ding return and collection processes.
8 Legal information
8.1 Liability
The manufacturer recommends using the device only under the specified
conditions and for the intended purposes, and only with the modular com-
ponent combinations tested for the prosthesis. The device must be main-
tained according to the instructions for use. The manufacturer is not liable
for damage caused by component combinations that were not authorised
by the manufacturer.
8.2 CE Conformity
This device meets the requirements of the 93 / 42 / EEC guidelines for medi-
cal devices. This device has been classified as a class I device according
Ottobock | 25