Table of Contents
Advertisement
2.5.3 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin plugable
terminal block located on the front panel. Please use the following pictures to
find the general wiring configuration.
Pin No.
1
2
3
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1. DC power source and IGN share the same ground.
2. RCX-1500 PEG supports 6V to 36V wide range DC power input in ATX/AT
mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery
scenario.
3. For proper ignition control, the power button setting should be "Power Down"
mode.
©Vecow RCX-1500 PEG User Manual
IGN
Definition
Ignition
SW+
SW-
V+
V-
In Windows for
example, you need
to set "When I press
the power button" to
Shut down.
GETTING TO KNOW YOUR RCX-1500 PEG
IGN
48
Advertisement
Table of Contents
