Connect The Harness To The Boom Function Controls - Raven AutoBoom Installation Manual

Chapter 4

Connect the Harness to the Boom Function Controls

Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or
1.
115-0230-085).
Route the connectors to the AutoBoom valve (P/N 063-0131-125).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
5.
Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.
6.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
7.
Locate the Left Prop and Right Prop connectors on the harness cable.
8.
Connect the Left Prop connector to Port 5A on the AutoBoom valve.
9.
Connect the Right Prop connector to Port 13A on the AutoBoom valve.
10.
Machine's Left and Right Tilt Boom Function Coils
FIGURE 14.
Locate the machine boom function coils near the machine's boom hydraulic valve.
11.
Disconnect the connector from the machine's Left Tilt Up coil.
12.
Install a boom sense adapter cable (P/N 115-0171-558) between the coil and the machine's coil connector.
13.
Connect boom sense adapter cables between the left tilt down, right tilt up, and right tilt down coils and the
14.
coil connectors.
On the harness cable, locate the Left Solenoid Sense connectors. Isolate the connector labeled Up and
15.
connect it to the left tilt up coil via the installed boom sense adapter cable.
Connect the down Left Solenoid Sense connector to the left tilt down coil via the installed boom sense
16.
adapter cable.
Connect the Right Solenoid Sense connectors to the machine's right tilt up and right tilt down coils via the
17.
installed boom sense adapter cables.
46 Case IH 3150/3185, Pre-2002 Tyler Patriot Open Center AutoBoom™ Installation Manual