Operating Instructions - ADJ ENCORE PROFILE 1000 WW User Instructions

OPERATING INSTRUCTIONS

LCD Backlight On/Off:
To set the LCD backlight to turn off after 20 seconds, press the MODE button until "OTHER" is displayed,
press the SET UP button until "OTHER BLGT:XX" is displayed. "XX" represents the current state. Press the
UP or DOWN buttons to set the backlight to turn "OFF" after 20 seconds or "ON" to stay on at all times.
Operating Modes:
The Encore Profile 1000 WW has three operating modes:
• Dimmer Mode - Adjust the intensity of the white color.
• Fade Mode - The unit will fade in and out.
• DMX control mode - This function will allow you to control each individual fixtures traits with a standard DMX
512 controller.
Dimmer Mode:
1. Plug the fixture in and press the MODE button until "MANUAL WHIT:XXX" is displayed.
2. Press the UP and DOWN buttons to adjust intensity.
3. After you have adjusted the output intensity you can then activate strobing by pressing the SET UP button
to enter strobing.
4. "STRO" will be displayed, this is strobing mode. The strobing can be adjusted between "00" (strobing off) to
"15" (fastest strobing).
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored to their
own individual needs. The Encore Profile 1000 WW has 3 DMX modes: 1 channel mode, 2 channel mode, and
3 channel mode. See page 11 for each mode's DMX traits.
1. This function will allow you to control each individual fixture's traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until "DMX MODE ADDR:XXX" is displayed. "XXX"
represents the current displayed DMX address. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes are listed
below:
• "CHAN: 01" is 1 Channel DMX Mode.
• "CHAN: 02" is 2 Channel DMX Mode.
• "CHAN: 03" is 3 Channel DMX Mode.
4. Please see page 11 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections to any
standard DMX controller.
Fade Mode:
1. Plug the fixture in and press the MODE button until "FADE RUN SPEED:XX" is displayed. "XX" represents a
number between 01-16.
2. Use the UP and DOWN buttons to find your desired color fade mode.
3. Press the SET UP button and "SPEED:XX" will be displayed. Use the UP and DOWN buttons to adjust the
speed of the color fade.
System Reset:
This will return the fixture to its factory settings.
1. Plug the fixture in and press the MODE button until "OTHER MODE" is displayed.
2. Press the SET UP button until "SYSRESET" is displayed.
3. Press the UP and DOWN buttons simultaneously to reset or press the MODE button to exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See page 12 for the different dimming curves.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR:XXX" is displayed.
2. Press the SET UP button until "DELAY:X" is displayed. "X" represents the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
A.D.J. Supply Europe B.V. – www.americandj.eu – Encore Profile 1000 WW Instruction Manual Page 7