O P E R AT I N G I N S T R U C T I O N S
DMX MODE:
Press MODE button and select DMX mode. When the display shows, "d.×××", press SETUP button to
choose DMX Address Set Mode, "d.×××"; DMX channels; and "CH.-×".
•
When "d.×××" is displayed, press UP or DOWN to select the DMX address (1-512).
•
When "CH.-×" is displayed, press UP or DOWN to select one of the seven different DMX channel
modes.
•
When there is no controller signal, the display will flash.
SECONDARY MODE:
Press MODE button to select Secondary Mode. When the display shows, "SEcd", press SET UP.
Note that the UP and DOWN buttons are disabled in this mode.
DIMMER MODE:
Press MODE button, then select Dimmer Mode. The display shows, "r.g.b.A". Press SETUP to se-
lect the display 4 colors (red"r.×××", green"g.×××", blue"b.×××", and amber"A.×××") then press UP or
DOWN button to set the dimming rate (0-255). Press SET UP button to choose the flash speed set
mode. When"FS.××" is displayed, press UP or DOWN button to adjust the flash speed. 00 turns off
flash, 01 is the slowest flash speed, and 99 is the fastest flash speed.
BUILT-IN PROGRAM SELECT MODE:
Press MODE button and select Built-In Program Select Mode. The display shows, "Pr.××". Press UP
or DOWN to select one of the built in programs (01-22), then press SET UP button to choose the Pro-
gram Speed Set Mode, Program Fade Time Set Mode, and the Flash Speed Set Mode.
•
When "SP.××" is displayed, press UP or DOWN button to adjust the program running speed (01-
99) from slow to fast.
•
When "Fd.××" is displayed, press UP or DOWN button to adjust the fade time (00-99) from fast to
slow: 00 turns off fade, 01 is the fastest, and 99 is the slowest.
•
When "FS.××" is displayed, press UP or DOWN button to adjust the flash speed (00-99) from slow
to fast: 00 turns off flash, 01 is the slowest, and 99 is the fastest.
Note: When the LED light is in Pr.21 and Pr.22, press SET UP button to choose the base color and
flow color. When "C1.××" is displayed, press UP or DOWN button to select the base color 0-15. When
"C2.××" is displayed, press UP or DOWN button to select the flow color 0-15.
AUTO-RUN MODE:
Press MODE button to select Auto Run Mode. When the display shows, "AUTO", press SET UP but-
ton to choose the Fade Time Set Mode, the Flash Speed Set Mode, and RF Remote Function On/Off
Mode.
•
When "Fd.××" is displayed, press UP or DOWN button to adjust the fade time (00-99). 00 turns off
fade, 01 is the fastest, 99 is the slowest.
•
When "FS.××" is displayed, press UP or DOWN button to adjust the flash speed (00-99). 00 turns
off flash, 01 is the slowest flash speed, and 99 is the fastest flash speed.
•
When the digital display shows "rF.on", press the "+" and "-" buttons to select RF Remote Function
On/Off. "rF.on" means that the RF remote function is always on, and "rF.oF" means that the RF
remote function is off.
12