Table of Contents
Advertisement
O P E R A T I N G I N S T R U C T I O N S
Full On Mode, 3.3W Mode, & Energy Saving Mode:
The PinPoint Gobo COLOR has 3 LED modes: full on mode, 3.3W mode, and energy saving mode.
When the PinPoint Gobo is set into energy saving mode, it will decrease the LED brightness gradu-
ally when the battery life is less than 80% in order to extend the battery life. NOTE: When the unit is
using DC power, the energy saving mode cannot be used.
•
When operating the device using the keys on the control panel, press the MODE button for 5 sec-
onds to switch between normal mode, 3.3W mode, and energy saving mode.
•
When using the ADJ LED RC2, press the BLACKOUT button for 5 seconds to switch between
operating modes.
•
When using the UC IR, press the STAND BY button for 5 seconds to switch between operating
modes.
•
Regardless of whether the device is being controlled from the control panel, LED RC2, or UC IR,
the LED mode is signified by the LEDs. In full on mode, all LEDs flash twice; in 3.3W mode, the
blue LED flashes 5 times; and in energy saving mode, the green LED flashes 10 times.
Low Battery Warning:
When the battery power falls below 30%, the red & blue LED's will alternately flash rapidly for 5
seconds each time the power is switched ON. After the 5 seconds, the unit will function normally. The
device does this to inform the user that charging is required.
Operating Power:
There are two ways to supply power to this unit: battery power or DC power.
•
DC Power - To run the unit using DC power, plug the unit into a DC power source, and put the
POWER switch into the ON position.
•
Battery Power - To run the unit using Battery power, put the POWER switch in the ON position.
Mode Button Lock:
The MODE button will lock itself after 30 seconds of inactivity. To unlock the unit, press and hold the
MODE button for 3 seconds.
Mode Operation:
Each press of the MODE button will cycle through the different operating modes. The operating
modes are listed below in the order in which the unit cycles through them. Please note: When power
is turned OFF and turned back ON, the unit will start in the last operating mode.
•
Order of Operating Modes: 64 Color Macros > Fast Fade > Fast Change > Slow Fade > Slow
Change > LED Off
Pressing the MODE button again after "LED Off" will return the unit to the first color macro.
10
Advertisement
Table of Contents
