Kb-Adv100 Optional Programming Keypad; Membrane Keypad; Meaning Of Leds - gefran ADP200 Quick Start Up Manual, Specification And Installation

8.1.2 KB-ADV100 optional programming keypad

Drive status indicator LEDs

Membrane keypad

The optional programming keypad is used to display the status and diagnostics parameters during operation. It has
a strip of magnetic material on the back so that it can be attached to the front of the drive or other metal surface (e.g.
door of the electrical panel). The keypad can be used remotely from distances of up to 15 m. A 70 cm-long connec-
tion cable is supplied as standard. Up to 5 sets of parameters can be saved using the KB-ADV100 keypad and sent to
other drives.
8.1.2.1 Membrane keypad
This section describes the keys on the membrane keypad and their functions
Symbol Reference
Start
Stop
ESC Escape
FWD
Forward/Reverse Reverses the direction of rotation of the motor
REV
LOC
Local/Remote
REM
RST Reset
CUST Custom
DISP Display
E Enter

Up

Down

Left
 Right

8.1.2.2 Meaning of LEDs

LEDs Colour
T+ Yellow
T- Yellow
EN Green
ILIM Red
N=0 Yellow
AL Red
ADP200 • Quick installation guide - Specifications and connection
→
T+ T-
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
05 REFERENCES
ESC
→
FWD
REV
LOC
REM
Description
Starts the motor
Stops the motor
Returns to the higher level menu or submenu. Exits a parameter, a list of parameters, the list of the last 10 parameters.
Can be used to exit a message that requires use of this.
Changes the method of use from local to remote and vice versa.
Is active only if the drive is not enabled.
Resets alarms, only if the causes have been eliminated.
Displays the last 10 parameters that have been modified. To exit these functions, press the
Displays a list of drive functioning parameters.
Enters the submenu or selected parameter, or selects an operation. It is used when modifying parameters to confirm the new
value that has been set.
Moves the selection up in a menu or list of parameters.
During modification of a parameter, increases the value of the digit under the cursor.
Moves the selection down in a menu or list of parameters.
During modification of a parameter, decreases the value of the digit under the cursor.
Returns to the higher level menu. During modification of a parameter, moves the cursor to the left.
Accesses the submenu or parameter selected. During modification of a parameter, moves the cursor to the right.
Meaning of LEDs
the LED is lit, when the drive operates with a positive torque
the LED is lit, when the drive operates with a negative torque
The LED is lit during IGBT modulation (drive operating)
When this LED is lit the drive has reached a current limit condition. During normal functioning, this LED is off.
The LED is lit when motor speed is 0.
The LED is lit when the drive signals that an alarm has been triggered
EN ILim n=0 AL
←
5-line x 21 character alphanumerical LCD display
DISP
E
CUST
RST

key.
47