Identifiers; Telephone Communication Parameters; Parameters Of Communication Via Ethernet (Tcp/Ip) Network - Satel VERSA Programming Manual

20

Identifiers

The identifiers can be programmed:
– in the D
LOAD
this window is available in the C
the Ctrl+R key combination.
– in the keypad, 0. S
VERSA identifier – identifier of the alarm control panel which makes it possible to
identify the control panel and match the data file to it, provided that the data file has
been saved on the computer. It consists of 8 hexadecimal characters (digits or letters
from A to F). The same identifier must not be programmed for different control panels
operated from the same computer (the D
distinguishing between them).
D X identifier – identifier of the computer with D
LOAD
is effected, including verification of identifiers, the control panel will only establish
connection with the program which uses the valid identifier. It consists of 8
hexadecimal characters (digits or letters from A to F).
Note: In case of establishing communication with the alarm system whose identifiers
have factory defaults (00000000), the D
generated identifiers.

Telephone communication parameters

The telephone numbers are programmed in:
– D X program, "Identifiers and tel. no" window;
LOAD
– keypad, 0. S
The number of rings is programmed in:
– D X program, "Global parameters" window;
LOAD
– keypad, 7. A
Options related to remote programming via the modem (e.g. A
D ) are described in Section G
OUBLE CALL
VERSA panel telephone number – telephone number of the control panel. Available
for programming only in D
PC telephone number – telephone number of the computer from which the control
panel is to be programmed. It should be programmed if the telephone connection is
to be made by the control panel (the panel initiates the connection or calls back).
Rings before answer – number of rings after which the control panel will go off hook.

Parameters of communication via Ethernet (TCP/IP) network

The IP address of computer with D
communication through Ethernet network, encryption key (D
D X->ETHM-1
LOAD
section ETHM-1
– in the "Versa – Structure" window, "Hardware" tab, after the ETHM-1 module has
been selected in the list;
– in the keypad, by means of the S
1. K
. &
PDS
the list that will be displayed (the programming is effected by the "step by step"
method).
Programming Manual
X program, "Identifiers and tel. no" window. The command for opening
M
RV OD CONFIG
M submenu (only computer telephone number).
RV OD CONFIG
submenu.
NSWERING
X program.
LOAD
option are programmed for the ETHM-1 module (see:
CONNECTION
ETHERNET MODULE
. 2. S
EXPS ETTINGS
menu. You can also open it by using
OMMUNICATION
submenu.
X program will be incapable of
LOAD
LOAD
LOBAL OPTIONS
X program (S
LOAD
– p. 47):
function (S
ETTINGS
), after the ETHM-1 module has been selected from
X program. If communication
LOAD
X program will suggest random
NSWERING
.
), TCP port for
ERVER
X
LOAD
ERVICE MODE
SATEL
– and
MODEM
) and the
KEY
2. H
ARDWARE