Entering Data By Means Of The Led Keypad; Selection From The Single-Choice List; Selection From The Multiple-Choice List; Entering Decimal Values - Satel VERSA Programming Manual

14
Key
! ?
a b
d e
g h
j k
m n
p q
t u
w x
.
Table 3. Characters available in the LCD keypad when entering names. The lower case
letters are available under the same keys (to change the letter case, press

2.1.8 Entering data by means of the LED keypad

The data being entered are presented by means of LEDs. The method of programming
depends on the type of data to be entered by service function. To save the data in the control
panel, press the
key.

Selection from the single-choice list

The lit LEDs show the available items on the list. Blinking LED indicates the current
position of the cursor and, consequently, the item which is currently selected. The
key moves the cursor to the right, and the
numbered, you can use the numerical keys to select the item at once and move the
cursor there. The

Selection from the multiple-choice list

The lit LEDs show which items have been selected. Blinking LED indicates the current
position of the cursor. The
to the left. Press any numerical key to toggle the status of the LED over which the
cursor is placed (depending on its current status, the LED comes on or goes out). The
and

Entering decimal values

After entering the selected parameter programming function, the currently programmed
value will be presented in binary mode on LEDs 1-12 (see: Fig. 1). LEDs 1-4 present
(see: page 15 Table 4) the first digit , LEDs 5-8 – the second one, LEDs 9-12 – the third
one. To enter the new numerical value, press the corresponding numerical keys. You
can enter:
– 1 digit – it will be shown on LEDs 1-4 (the other LEDs are off);
– 2 digits – they will be shown on LEDs 1-8 (the other LEDs are off);
– 3 digits – they will be shown on LEDs 1-12.
The arrow keys are not used.
Correction of the entered value is only possible after re-entering the selected parameter
programming function.
Programming Manual
Characters available after next keystroke

' ` "
c 2
f 3
i 4
l 5
o 6
r s 7
v
y z 9
, : ; +
key. To exit the function without saving the changes, press the
and
key moves the cursor to the right, and the
keys are not used.
{ } $ % &
- / = _
key – to the left. As all the LEDs are
keys are not used.
@ \ ^ |
8
< > ( )
SATEL
# 1
[ ] 0
).
key –