Access To Functions By Using Arrow Keys; Access To Functions By Using Numerical Shortcuts - Satel VERSA Programming Manual

6
If the S
ERVICE MODE FROM
Section G
LOBAL OPTIONS
lowest address is set:
– LCD: the
message "Restore factory settings ? 1=Yes" will come up on the display;
– LED: the
will be blinking rapidly.
Pressing the key with digit 1 will reset the control panel to its factory settings,
but will enable entering the service mode.

2.1.3 Access to functions by using arrow keys

This way of starting the function is only available in the LCD keypad.
1. Use the
cursor is: ).
2. Press the
previous menu/submenus, and the
3. Repeat the steps described in 1 and 2 until you find the required function (the shape of
function indicating cursor is: ). Press the
4. When entering new settings, accept them using the
Press the

2.1.4 Access to functions by using numerical shortcuts

This way of starting the function is available in all types of keypads supported by the VERSA
control panels. All submenus and functions are numbered. In order to enter a submenu, just
press the key with number corresponding to the submenu number. In order to start a
function, press the key with number corresponding to the function number, and then the
key. You can quickly start the selected function by entering at once a sequence of
some digits (corresponding to the consecutive submenu numbers and the function number)
and confirming them by pressing the
For example, to start the expander identification function, first enter the service mode and
then press in turn the
- enter 2. H
- enter 1. K
- start 1. I
In the LCD keypad, use the
function to a submenu, and use the
menu/submenu.
In the LED keypad, use the
Notes:
• When using the numerical shortcuts, remember that the sequence of digits which starts
a function e.g. from the service mode main menu level will not start the same function
from the submenu level.
• In the LCD keypad, the shape of the submenu cursor is:
indicating cursor is : .
Programming Manual
RESET
) then, depending on the type of keypad in which the
, and
and LEDs of the second partition will be lit and the
and keys to find the required submenu (the shape of submenu
or key to enter the submenu (use the
key to cancel entering the new settings and return to the submenu.
submenu;
ARDWARE
& . submenu;
PDS EXPS
function.
DENTIFICAT
key to return from a submenu to the main menu or from a
key to return to the main menu.
option is disabled in the control panel (see:
PINS
LEDs of the second partition will be lit, and the
key to return to the main menu).
or
key.
keys, where:
key to return from a submenu to the previous
key to return to the
key to start the function.
key and return to the submenu.
, and that of the function
SATEL
LED