Configuration Of 433 Mhz Wireless Detectors Using Lcd Keypad; 433 Mhz Wireless Detectors And Zone Programming; Proximity Card Arm/Disarm Device - Satel VERSA Programming Manual

SATEL
relating to the 433 MHz wireless detectors are not read after clicking on the
saved after clicking on the
disable the option, click on the "Presence contr" column (symbol X indicates that the option is
enabled).

7.4.3 Configuration of 433 MHz wireless detectors using LCD keypad

You can enable the presence control option already when adding a 433 MHz wireless
detector (see: I
NSTALLER MANUAL
Additionally, you can enable / disable the presence control option in the service mode, using
the C .
ONFIG DEVICE
2. C
.
ONFIG DEVICE
1. Having started the function, use the
wireless detector for which you want to enable / disable the option is assigned.
2. Press the
3. Press any digit key to enable / disable the option (indications of the symbol in the upper
right corner: – option disabled,
4. Press the

7.4.4 433 MHz wireless detectors and zone programming

When programming the zones to which 433 MHz wireless detectors are assigned, take into
consideration the specific character of the operation of such detectors. The wireless
detectors send information on violations, tampers and low battery status. The information on
violations and tampers is sent to the zone to which the detectors are assigned. These zones
can be programmed as:
• NC, NO or EOL – the zone will inform about detector violation;
• 2EOL/NC or 2EOL/NO – the zone will inform about detector violation and tamper.
The information on tamper and tamper restore is sent by the detector in real time.
How information about violation is sent depends on the detector operating mode:
– normal – the detector sends information on violation and violation restore in real time
(the zone status corresponds to the detector status);
– energy save (available in some detectors) – after sending information on violation, the
detector will not send any further information about violations for 3 minutes (the zone
will be violated for 2 seconds after the controller receives the transmission containing
information on detector violation).
7.5

Proximity card arm/disarm device

LED R – reaction of the partition after removal of the card from the device, when the red LED
is lit. The partition can be fully armed or its status may remain unchanged.
LED G / LED Y – reaction of the partition after removal of the card from the device, when the
green / yellow LED is lit. One of the three armed modes can be enabled in the partition,
the partition can be disarmed or its status may remain unchanged.
Note: In the D
LOAD
device is to be programmed by clicking in table on the field corresponding to the
selected partition. A double click on the field will change the icon displayed in it. In the
LCD keypad, the type of partition reaction should be selected from the list.
button in the D
).
function (2. H
).
key.
key.
X program, the type of partition reaction after removal of the card from the
VERSA
X program main menu). To enable /
LOAD
1. K
ARDWARE PDS
and keys to select the zone to which the
– option enabled).
. 3. W
&
EXPS IRELESS MOD
59
button or
.