SATEL
4. Triggering zones [actually, the partition armed mode is selected for the outputs with
functions 18. A
with function 19. T
5. Output options.
6. Output name [only in LCD keypad].
6.1
Numeration of outputs in the system
The control panel supports outputs having numbers from 1 to 12. The numbers of hardwired
and wireless outputs may coincide. The control panel will support them simultaneously.
6.1.1 Hardwired outputs
The hardwired outputs are assigned numbers automatically:
• the outputs on control panel main board have numbers from 1 to 4;
• the outputs in expander have numbers from 5 to 12.
6.1.2 Wireless outputs
The wireless outputs can be assigned numbers from 1 to 30. The numbers are assigned
during the procedure of adding wireless devices (the output number is the same as the
number of selected zone). You should bear in mind that the control panel does not support
the outputs with numbers from 13 to 30.
6.2
Output functions
0. N
OT USED
1. E
XTERNAL SIREN
2. I
NTERNAL SIREN
alarms.
Note: The way of signaling the tamper alarms by the outputs with functions 1. E
and 2. I
SIREN
and T
AUDIBLE
3. B
– signals the alarms from 0 to 7 type zones.
URGLARY
4. F
– signals the fire alarms from keypad and from 10. 24
IRE ALARM
5. "DURESS"
ALARM
alarm clearing.
6. P
– signals the panic alarms from keypad and from 7. 24
ANIC ALARM
7. AUX.
– signals the medical assistance call alarms triggered from keypad and from
ALARM
9. 24
type zones.
H MEDICAL
8. A
–
LARM
NOT VERIFIED
9. A
-
LARM
VERIFIED
10. T
AMPER ALARM
11. F
IRE DETECTORS POWER SUPPLY
detectors with automatic verification alarm. After violation of the fire zone the output will be
disabled for 16 seconds. If, after the power is turned on again, another violation from the
fire zone occurs, the fire alarm will be triggered.
12. P
OWER SUPPLY ON ARMED
should not be active when the system is disarmed. It gets activated at the moment of
starting the arming procedure (the exit delay is not taken into account).
13. Z
ONE VIOLATION
and 20. A
RMED STATUS
(see: Section O
ROUBLE STATUS
– signals the burglary, panic and tamper alarms.
– signals the burglary, panic and tamper alarms, as well as the warning
depends on the global options T
NTERNAL SIREN
AMPER ALARM ON INTERNAL SIRENS
– signals that code with D
– signals the unverified alarms.
– signals the verified alarms.
– signals the tamper alarms.
– the dedicated output for power supply of the detectors which
– signals violation of the zones.
VERSA
/
LARM
ARM STATUS
UTPUT PARAMETERS
.
right was used for arming/disarming or
URESS
– the dedicated output for power supply of the fire
, and the troubles for the output
)].
AMPER ALARM ALWAYS
type zones.
H FIRE
type zones.
H PANIC
39
XTERNAL
Need help?
Do you have a question about the VERSA and is the answer not in the manual?
Questions and answers