Step By Step" Programming Method; Service Mode Menu - Satel VERSA Programming Manual

SATEL

2.1.5 "Step by step" programming method

Some components of the system (e.g. zones, outputs, expanders, wireless devices, event
codes for reporting, etc.) should be programmed using the "step by step" method. When the
function is called up and the component to be configured selected from the list, the first
parameter available for programming will be displayed. Irrespective of whether or not it will be
modified, pressing the
parameter (the changes will be saved). After all available parameters are configured, return
to the submenu follows in the LCD keypad, and to the main menu in the LED keypad. The
programming can be terminated at any moment by using the
submenu). The
step number in binary mode (see: page 15 Table 4).

2.1.6 Service mode menu

Shown in square brackets are sequences which enable calling up a particular submenu or
starting a particular function from the main menu level.
0. SrvMod config
[00#]
[01#]
[02#]
[04#]
[06#]
[07#]
[08#]
[09#]
1. Partitions
[11#]
[12#]
[13]
[14]
[15#]
[16#]
[17#]
2. Hardware
[21]
key will take you automatically to programming the next
and LEDs of the first and second partitions show the programming
0. Serv.Mode end
1. VERSA id.
2. DloadX id.
4. DloadX tel.
6. SrvMod opt.
7. Restore all
8. Default usr.
9. STARTER
1. Part. 1 zones
2. Part. 2 zones
3. Part. 1 times
[131#]
[132#]
[133#]
[134#]
[135#]
[136#]
4. Part. 2 times
[141#]
[142#]
[143#]
[144#]
[145#]
[146#]
5. Part. 1 name
6. Part. 2 name
7. Part. options
1. Kpds. & exps.
VERSA
1. Exit delay
2. Entry delay
3. Warning
4. Verification
5. Autoarm delay
6. A-arm defer
1. Exit delay
2. Entry delay
3. Warning
4. Verification
5. Autoarm delay
6. A-arm defer
key (you will return to the
7