Initiating Connection From The Dload; Initiating Connection By The Control Panel - Satel VERSA Programming Manual

SATEL
Initiating connection from the D
calling back and establishing connection
This method ensures better security of the system, because the control panel may
only be remotely programmed from a specified locality. Make sure that in the control
panel:
• you have programmed telephone number of the computer from which the control
panel is to be programmed (S
• the A
NSWERING
1. O
PTIONS
• you have defined the number of rings after which the control panel will go off-hook
(S
ERVICE MODE
• you have defined whether the control panel will go off-hook after the first, or after the
second call (S
Telephone number of the control panel must be programmed in the D
1. Start the D
2. Initialize the modem connected to the computer. For the modem to be initialized,
click on the
bps modem. The window will then open where the modem initializing information will
be shown.
3. Click on the "Connect" button.
4. After the preprogrammed number of rings (after the second call, if the D
option is enabled), the control panel will answer the call, acknowledge receiving the
connection, and then disconnect.
5. The control panel will call back the number programmed in the control panel and the
connection will be established, which will be indicated by the D
appropriate message.

Initiating connection by the control panel

Like the previous method, also this one ensures enhanced security of the system,
because the control panel may only be remotely programmed from a specified locality. It
can be applied if the system user prefers that the remote programming cannot be
carried out without his knowledge. Telephone number of the computer from the control
panel is to be programmed must be programmed in the control panel (S
0. S
M
RV OD CONFIG
1. Start the D
2. Initialize the modem connected to the computer. For the modem to be initialized,
click on the
bps modem. The window will then open where the modem initializing information will
be shown.
3. Enter in the keypad the service code (by default 12345) or the code of user having
the DOWNLOAD/SERVICE privilege and press the
4. Press in turn the
start).
5. The D
LOAD
message.
ERVICE MODE
– option is enabled (S
MODEM
M
ODEM ANSWERING
7. A
NSWERING
3. G
ERVICE MODE
X program on computer.
LOAD
button and, from the menu that will be displayed, select the 300
4. D
X
LOAD
X program on computer.
LOAD
button and, from the menu that will be displayed, select the 300
X program will signal establishing communication by an appropriate
VERSA
X program, but with the control panel
LOAD
0. S
RV
);
1. R
.);
INGS TO ANS
. 1. O
LOBAL PARAM
.).
TEL
keys (the S
4. D
M
OD CONFIG
3. G
ERVICE MODE
D
PTIONS OUBLE CALL
LOAD
X program by an
LOAD
key.
D TEL con. function will
TART WNL
23
X .);
LOAD TEL
.
LOBAL PARAM
).
X program.
OUBLE CALL
ERVICE MODE